FCM-Right Lowbeam Output Circuit Low

FCM-RIGHT LOWBEAM OUTPUT CIRCUIT LOW

FCM - Right Lowbeam Output Circuit Low:

WHEN MONITORED
With the ignition on

SET CONDITION
The FCM detects a short condition

POSSIBLE CAUSES
- Right lowbeam output circuit short to ground
- Power distribution center
- Front control module

1. INTERMITTENT CONDITION




Turn the ignition on.
With the DRBIII(R), clear all FCM DTC's.
Actuate the Lowbeam headlamps.
With the DRBIII(R), read the DTC information.

Q: Does the DRBIII(R) read: Right Lowbeam Output Circuit Low?

YES: Go To 2
NO: The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

2. RIGHT LOWBEAM OUTPUT CIRCUIT SHORT TO GROUND




Turn the ignition off.
Disconnect the IPM C7 harness connector.
Measure the resistance between ground and the Right Lowbeam Output circuit.

Q: Is the resistance below 5.0 ohms?

YES: Go To 3
NO: Repair the Right Lowbeam Output circuit for a short to ground. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

3. FRONT CONTROL MODULE
Turn the ignition off
Disconnect the FCM connector.
Disconnect the IPM C7 harness connector.
Measure the resistance between ground and the Right Lowbeam Output circuit in the IPM.

Q: Is the resistance below 5.0 ohms?

YES: Replace the Power Distribution Center(PDC). Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: Replace the Front Control Module. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test