Lower Instrument Panel

INSTRUMENT PANEL RIGHT LOWER TRIM

WARNING: Follow all Warnings for airbag component service. Refer to Airbag System.

REMOVAL

1. Open deck lid.
2. Remove four bolts to battery compartment cover and remove cover.
3. Disconnect and isolate the battery negative cable.
4. Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or instrument panel component service.
5. Remove the cluster bezel.
6. Remove the glove box.
7. Remove the glove box striker.
8. Remove the two screws to the left of the glove box opening.
9. Remove three screws to instrument panel right lower trim and remove from panel.
10. Disconnect the glove box light electrical connector.

INSTALLATION

1. Install five screws to instrument panel right lower trim.
2. Install three screws retaining glove box assembly.
3. Connect one electrical connector on cluster bezel, place in position over retaining slots and firmly snap into place.
4. Connect one electrical connector to instrument panel center bezel and install six screws to center bezel.
5. Connect one electrical connector to center console, place into position and install eight screws to console.
6. Install floor console bezel and parking brake body.
7. Install shifter shaft with knob and body.
8. Install six allen screws to shifter bezel.
9. Connect the battery negative cable.
10. Place battery access cover into place and install four bolts.
11. Close deck lid.
12. Verify vehicle and system operation.