Memory Positioning Systems: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the front door trim panel switch bezel from the driver side front door. Using a thin flat- bladed pry tool, gently pry the switch bezel away from the drivers door trim panel.
3. Disconned the memory switch wire harness connector from the memory switch.
4. Remove the two screws that secure the memory switch to the back of the driver side front door trim panel switch bezel.
5. Remove the memory switch.

INSTALLATION
1. Position the memory switch and install and tighten the two screws that secure the memory switch to the back of the driver side front door trim panel switch bezel. Tighten the screws to 2.2 Nm (20 in. lbs.).
2. Reconnect the memory switch wire harness connector to the memory switch.
3. Install the trim panel switch bezel onto the driver side front door.
4. Reconnect the battery negative cable.