Power Sliding Door Module: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the appropriate door trim panel from the vehicle.
3. Remove the weather shield.
4. Disconnect the power door control module electrical connectors. Slide the red locking tab out (away from module) and depress connector retaining tab, while pulling straight apart.

Power Side Door Components:

5. Remove the control module retaining screw.
6. Remove the module from the vehicle.

INSTALLATION
1. Position the sliding door control module and install the retaining screw.
2. Connect the electrical connectors. Slide the locking tab into the locked position.
3. Install the weather shield.
4. Install the appropriate door trim panel on the vehicle.
5. Connect the battery negative cable.
6. Using an appropriate scan tool, check and erase any power door control module diagnostic trouble codes.
7. Verify power door system operation. Cycle the power door through one complete open and close cycle.