Disassembly - Rear Bushing - Hydro

DISASSEMBLY - REAR BUSHING - HYDRO

1) Remove the lower control arm from the front suspension cradle.
2) Mount the lower control arm in a vise without using excessive clamping force.

Fig. 24 HYDRO-BUSHING REMOVAL:

3) Install Remover, Special Tool 8460, on hydro-bushing as shown (Fig. 24). Removal Pin, Special Tool 8460-3, must extend though hole in center of bushing rear.
4) Tighten forcing screw of Bridge (Special Tool 8460-1), removing bushing from lower control arm.