Front Seat Riser - Power
RISER-FRONTREMOVAL
Power Length Adjuster
1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Seats / Service Precautions.
2. Unbolt the seat from the floor as necessary to gain access to the riser bolts.
3. Move the seat to the forward position on the tracks, tip the seat backwards in vehicle and remove the seat adjuster bolts/nuts (3).
4. Move the seat to the reward position on the tracks and remove the front seat adjuster bolts/nuts (3).
NOTE: Manual seat length adjuster shown, power similar.
5. If the seat cannot be moved forward or backward, remove the seat cushion.
6. Remove the four bolts (1) and remove the motor and cable assembly (2) from the length adjuster assembly.
CAUTION: When the motor and cable assembly are removed from the tracks discard the length adjuster assembly and replace with a new one.
7. Disconnect and isolate battery negative cable.
8. Remove the seat off of the risers and disconnect the electrical connectors.
9. Disconnect strain gauge electrical connectors (1), if equipped.
10. If equipped, remove the strain gauge bolts (2) and remove the strain gauges as necessary.
INSTALLATION
Power Length Adjuster
1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Seats / Service Precautions.
2. If equipped, install the strain gauges and install the bolts (2).
3. Tighten the bolts to 40 N.m (30 ft.lbs.).
4. Position the seat into the vehicle onto the risers and connect the electrical connectors.
5. Move the seat to the forward position on the tracks and install the seat adjuster bolts/nuts (3).
6. Tighten the bolts attaching the adjuster to the risers/strain gauges to 45 N.m (33 ft.lbs.).
7. Move the seat to the reward position on the tracks and install the front seat adjuster bolts/nuts (3).
8. Tighten the bolts attaching the adjuster to the risers/strain gauges to 45 N.m (33 ft.lbs.).
9. If necessary, connect the strain gauge electrical connections (1).
CAUTION: When the motor and cable assembly are removed from the tracks discard the length adjuster assembly and replace with a new one.
10. Bolt the seat to the floor.