Power Front Passenger Seat
SEAT WEIGHT SENSORPOWER FRONT PASSENGER SEAT
REMOVAL
NOTE: If the vehicle is equipped with a power front passenger seat, to remove the adjuster from the riser it is necessary to have battery power to move the seat forward and rearward to access the mounting bolts.
1. Remove front passenger seat mounting bolts.
2. Remove the adjuster to riser mounting bolt (3).
3. Disconnect and isolate the battery negative cable.
WARNING: WAIT TWO MINUTES FOR THE AIRBAG SYSTEM RESERVE CAPACITOR TO DISCHARGE BEFORE BEGINNING ANY AIRBAG SYSTEM OR COMPONENT SERVICE. FAILURE TO DO SO MAY RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT, PERSONAL INJURY OR DEATH.
4. Remove the two nuts (2) holding the seat weight sensor (4) to the seat riser.
5. Disconnect the one electrical connector (1).
INSTALLATION
NOTE: If the vehicle is equipped with a power front passenger seat, to remove the adjuster from the riser it is necessary to have battery power to move the seat forward and rearward to access the mounting bolts.
1. Position the seat weight sensor onto passenger front seat riser.
2. Install the two nuts (2) holding the seat weight sensor (4) to the seat riser. Torque nuts to 40 N.m (30 ft. lbs.).
3. Connect the one electrical connector (1).
4. Install the adjuster to riser mounting bolt (3). Torque nuts to 45 N.m (33 ft. lbs.).
5. Install the front passenger seat bolts.
WARNING:
- DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE SYSTEM TEST IS NOT PERFORMED FIRST.
- FOLLOWING SUCCESSFUL COMPLETION OF THE AIRBAG SYSTEM TEST PROCEDURE, THE OCCUPANT CLASSIFICATION SYSTEM VERIFICATION TEST MUST BE DONE USING A SCAN TOOL AND THE APPROPRIATE DIAGNOSTIC INFORMATION.