Ash Tray: Service and Repair

REMOVAL




1. Disconnect and isolate the negative battery cable.
2. Remove the gear shift center bezel from the floor console (4).
3. Set the emergency brake and place the gear shift lever into Low gear.
4. Using a trim stick C-4755 or equivalent (1), remove the ash receiver (2) from the instrument panel (3) by releasing the snap retainers from the instrument panel.




5. If equipped, disconnect the wire harness connectors (2) from the heated seat switches and remove the switches as required.
6. Disconnect the wire harness connector (3) from the lighter assembly as required.
7. Remove the ash receiver from the vehicle.

INSTALLATION




1. If equipped and removed, install the heated seat switches into the ash receiver and connect the wire harness connectors (2) to the switches.
2. If removed, install the lighter assembly into the ash receiver and connect the wire harness connector (3) to the lighter.
3. Install the ash receiver assembly (1) into the instrument panel by carefully pushing the receiver housing into the instrument panel until the snap retainers are fully seated.
4. Install the gear shift center bezel onto the floor console (4)
5. Place the gear shift lever into Park and release the emergency brake.
6. Reconnect the negative battery cable.