Windage Tray

WINDAGE TRAY

REMOVAL





1. Disconnect negative battery (1) cable located in the trunk.
2. Raise vehicle.





3. Remove lower splash shield retaining bolts (1) and splash shield (2).





4. Remove oil filter (3).
5. Remove oil pan (4).





6. Remove oil pump pickup tube (2).
7. Remove windage tray/outer main bearing cap bolts (3).
8. Remove windage tray (1).

INSTALLATION





NOTE: Slots in windage tray should be on the right side of engine. If windage tray is improperly installed, damage to oil pan could result.

1. Install windage tray (1) torque mounting bolts to 27 Nm + 1/4 turn (20 ft. lbs. +1/4 turn).
2. Install oil pump pick up tube, torque mounting bolts to 28 Nm (250 inch lbs.).





3. Install oil pan.
4. Install oil filter (3).





5. Install lower splash shield (2) and retaining bolts (1)
6. Lower vehicle.
7. Fill with correct grade of oil.





8. Connect negative battery (1) cable located in trunk.
9. Start engine and check for leaks.