Hose - Supply

HOSE - SUPPLY
REMOVAL





1. Disconnect and isolate battery negative cable (2) from battery post.
2. Siphon power steering fluid from pump reservoir.
3. Remove air cleaner housing and inlet tube to throttle body.





4. 2.7L/3.5L Engines - Remove hose clamp (2), then supply hose (3) from pump (1).





5. 5.7L/6.1 L Engines - Remove hose clamp, then supply hose (3) from pump (1).





6. Remove hose clamp, then supply hose (3) at reservoir (2).
7. Remove supply hose from vehicle.

INSTALLATION





1. Install reservoir end of supply hose (3) on reservoir hose fitting. Install clamp securing hose in place.





2. 2.7L/3.5L Engines - Install supply hose (3) on pump. Install clamp (2) securing hose in place.





3. 5.7L/6.1L Engines - Install supply hose (3) on pump (1). Install clamp securing hose in place.
4. Install air cleaner housing and inlet tube.





5. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
6. Fill pump reservoir with fluid and perform pump initial operation procedure.