Overhead Console

READING LAMP

OVERHEAD CONSOLE

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Using a trim stick (special tool #C-4755) or equivalent, gently pry out the top (toward windshield) side of the reading lamp lens.




3. Lift the top of the lens up and slide forward (toward windshield) until the tab is released from the overhead console.
4. Gently pull the lamp out of the overhead console.

INSTALLATION




1. Firmly push the lamp into the overhead console.
2. Place the tab inside the rear edge of the overhead console. Carefully push down on the from of the lens making sure to snap in both sides of the lens.
3. Connect the battery negative cable.