Rear

SENSOR-WHEEL SPEED-REAR

REMOVAL





1. Raise vehicle on hoist.
2. Remove brake line mounting nut (4) and remove the brake line (3) from the sensor stud.
3. Remove the park brake cable (2) and bracket (1) from the sensor stud.
4. Disconnect the electrical connector (6).





5. Remove mounting stud (2) from the sensor (5).
6. Remove sensor (1) from differential housing (3).

INSTALLATION





1. Connect harness to sensor (1). Be sure seal is securely in place between sensor and wiring connector.
2. Install O-ring on sensor (if removed).
3. Insert sensor (1) in differential housing (3).





4. Install the sensor mounting stud and tighten to 24 Nm (200 inch lbs.).
5. Reconnect the electrical connector (6).
6. Install the brake line (3) on the sensor stud.
7. Install the park brake cable (2) and bracket (1) to the stud and install the nut (4).
8. Lower vehicle.