Operation CHARM: Car repair manuals for everyone.

Removal and Installation

WARNING: TO AVOID PERSONAL INJURY OR DEATH, ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, AIRBAG, OCCUPANT CLASSIFICATION SYSTEM, SEAT BELT TENSIONER, IMPACT SENSOR, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT.

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the cluster bezel from the instrument panel.
3. Remove the four screws (3) that secure the instrument cluster (2) to the instrument panel structural support (1).




4. Pull the instrument cluster rearward far enough to access and disconnect the instrument panel wire harness connectors (2) from the connector receptacles (1) on the back of the cluster housing.
5. Remove the instrument cluster from the instrument panel.

INSTALLATION




1. Position the instrument cluster close enough to the instrument panel to reconnect the instrument panel wire harness connectors (2) to the connector receptacles (1) on the back of the cluster housing.




2. Position the instrument cluster (2) into the instrument panel (1).
3. Install and tighten the four screws (3) that secure the instrument cluster to the instrument panel. Tighten the screws to 2 N.m (17 in. lbs.).
4. Reinstall the cluster bezel onto the instrument panel.
5. Reconnect the battery negative cable.

NOTE: Certain indicators in this instrument cluster are automatically configured. This feature allows those indicators to be activated or deactivated for compatibility with certain optional equipment. If a problem is noted that involves improper illumination of the cruise indicator, the electronic throttle control indicator, the tow/haul indicator, the service four-wheel drive indicator, the four-wheel drive low indicator, the four-wheel drive lock indicator, the transmission overtemp indicator, the security indicator or the gear selector indicator, disconnect and isolate the battery negative cable. After about five minutes, reconnect the battery negative cable and turn the ignition switch to the On position. The instrument cluster should automatically relearn the equipment in the vehicle and properly configure the configurable indicators accordingly.