Electronic Brake Control Module: Service and Repair

MODULE-ANTILOCK BRAKES

REMOVAL

NOTE: ABM module can be removed without removing the HCU unit.




1. Remove the left front tire and wheel assembly.
2. Disconnect the electrical connector from the ABM module.
3. Remove the module mounting screws (2).
4. Remove the module from the HCU (1) on ESP vehicles be careful not to damage the pressure sensor when removing the ABM.

INSTALLATION




1. Position the module on the HCU on ESP vehicles be careful not to damage the pressure sensor when installing the ABM.
2. Install the mounting screws (2) and tighten to 6 N.m (53 in. lbs).
3. Perform the ABS verification test with a scan tool.