B1947
B1947-POWER LIFTGATE PINCH SENSOR 2 CIRCUIT LOWB1947 - Power Liftgate Pinch Sensor 2 Circuit Low:
WHEN MONITORED
Whenever the Power Liftgate Module is awake.
SET CONDITION
The power liftgate module has detected the right pinch sensor circuit voltage is under 0.2 volts for over 10 seconds.
POSSIBLE CAUSES
- (Q78) Right pinch sensor signal wire short to ground
- Right pinch sensor
- Power liftgate module
Diagnostic Test
1. DTC PRESENT
NOTE: The vehicle should be at room temperature when this test is performed.
With the scan tool, record DTC's and any liftgate inhibitors.
Erase DTC's
Turn the ignition off, wait 10 seconds, then turn the ignition on.
Operate the liftgate several times.
With the scan tool, read DTCs.
Q: Does the scan tool display B1947-POWER LIFTGATE PINCH SENSOR 2 CIRCUIT LOW?
YES: Go To 2
NO: Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
2. RIGHT PINCH SENSOR SHORTED
Disconnect the Right Pinch Sensor connector
Erase DTC's
Turn the ignition off, wait 10 seconds, then turn the ignition on.
With the scan tool, read DTCs.
Q: Does the scan tool display B1947-POWER LIFTGATE PINCH SENSOR 2 CIRCUIT LOW?
YES: Go To 3
NO: Replace the right pinch sensor. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
3. (Q78) RIGHT PINCH SENSOR SIGNAL WIRE SHORT TO GROUND
Turn the ignition off.
Disconnect the Power Liftgate Module C2 connector.
Measure the resistance between ground and the (Q78) Right Pinch Sensor Signal circuit.
Q: Is the resistance below 10000.0 ohms?
NO: Replace the Power Liftgate Module. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
YES: Repair the (Q78) Right Pinch Sensor Signal wire for a short to ground. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test