Satellite Receiver
REGULAR CABNOTE: If the owner's satellite service was active before the satellite receiver module was replaced the new satellite receiver module will have to be activated. The existing satellite receiver module will have to be deactivated before the replacement satellite receiver module can be activated.
To activate Sirius satellite radio service, call Sirius at their toll-free number. Please have the following information available when activating a system:
- Electronic Serial Number / Sirius Identification Number (ESN/SID) of the unit to be replaced
- ESN/SID of the replacement receiver
- Vehicle Owner's name and address
- VIN The ESN/SID number can be obtained through the radio display by following the steps in the satellite radio.
The vehicle must be outside with the audio system powered on, in the satellite radio mode, to receive the activation signal.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Place front passenger seat in the forward position.
3. Remove the mounting fasteners.
4. Disconnect the antenna cable and electrical harness connectors.
5. Remove the satellite receiver.
INSTALLATION
1. Connect antenna cable and electrical harness connector to receiver.
2. Position module and install mounting fasteners. Tighten fasteners.
3. Connect battery negative cable.
QUAD CAB
REMOVAL
NOTE: If the owner's satellite service was active before the satellite receiver module was replaced the new satellite receiver module will have to be activated. The existing satellite receiver module will have to be deactivated before the replacement satellite receiver module can be activated.
To activate Sirius satellite radio service, call Sirius at their toll-free number. Please have the following information available when activating a system:
- Electronic Serial Number / Sirius Identification Number (ESN/SID) of the unit to be replaced
- ESN/SID of the replacement receiver
- Vehicle Owner's name and address
- VIN The ESN/SID number can be obtained through the radio display by following the steps in the satellite radio.
The vehicle must be outside with the audio system powered on, in the satellite radio mode, to receive the activation signal.
1. Disconnect and isolate the battery negative cable.
2. Remove the mounting fasteners.
3. Disconnect the antenna cable and electrical harness connectors.
4. Remove the satellite receiver.
INSTALLATION
1. Connect antenna cable and electrical harness connector to receiver.
2. Position receiver and install mounting fasteners. Tighten fasteners.
3. Connect battery negative cable.