Final Drive Control Module

C2101-BATTERY VOLTAGE HIGH





When Monitored
Continuously.

Set Condition
The Final Drive Control Module detects that system voltage is above 16.0 volts for 10 seconds with engine RPM greater than 350.

Possible Causes
- INTERMITTENT BATTERY VOLTAGE HIGH
- CHARGING SYSTEM DTCS PRESENT
- FINAL DRIVE CONTROL MODULE GROUND CIRCUITS OPEN OR HIGH RESISTANCE
- FINAL DRIVE CONTROL MODULE

Diagnostic Test
1. CHARGING SYSTEM DTCS PRESENT
Ignition on.
With the scan tool, select View DTCs in the Powertrain Control Module.
Are there any Charging System or related voltage DTCs present?
Yes >> Perform any Charging System DTC diagnostic procedures before continuing with this test.
No >> Go to 2.
2. DTC IS ACTIVE
With the scan tool, select View DTCs in the Final Drive Control Module.
Is the status Active for this DTC?
Yes >> Go to 3.
No >> Go to 5.
3. FINAL DRIVE CONTROL MODULE GROUND CIRCUITS OPEN OR HIGH RESISTANCE





Turn the ignition off.
Disconnect the Final Drive Control Module harness connector.
With a 12-volt test light connected to B+, check the Ground circuits in the Final Drive Control Module harness connector.

NOTE: The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.

Does the test light illuminate brightly for each of the Ground circuits?
Yes >> Go to 4.
No >> Repair the Ground circuit(s) for an open circuit or high resistance.
Perform FDCM VERIFICATION TEST. FDCM Verification Test
4. FINAL DRIVE CONTROL MODULE
View repair.
Repair
Replace the Final Drive Control Module.
Perform FDCM VERIFICATION TEST. FDCM Verification Test
5. INTERMITTENT WIRING AND CONNECTORS
The conditions necessary to set this DTC are not present at this time.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
While monitoring the scan tool data relative to this circuit, wiggle test the wiring and connectors.
Look for the data to change or for the DTC to reset during the wiggle test.
Were any problems found?
Yes >> Repair as necessary.
Perform FDCM VERIFICATION TEST. FDCM Verification Test
No >> Test complete.