P1502

P1502-VEHICLE SPEED SENSOR 1/2 CORRELATION - NON DRIVE WHEELS

P1502 - Vehicle Speed Sensor 1/2 Correlation - Non-Drive Wheels:

WHEN MONITORED:
Ignition on and vehicle moving. Brake pedal must not be applied.

SET CONDITION:
The PCM recognizes front axle speed is greater than rear axle speed. One trip fault.

POSSIBLE CAUSES
- Active BUS or communication DTCs
- Tire circumference
- PCM

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

DIAGNOSTIC TEST

1. ACTIVE DTC
Ignition on, engine not running.

NOTE: Check for any Bus Communication DTCs. If no Bus Communication DTCs are set, check for active DTCs stored in the Ant-Lock Brake Module. Any Bus Communication DTCs or VSS DTCs in the Ant-Lock Brake Module must be properly diagnosed before continuing.

With a scan tool, read DTCs.

Q: Is the DTC active at this time?

YES: Go To 2
NO: Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Component Tests and General Diagnostics
Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

2. VISUAL INSPECTION

NOTE: This code can set due to tire circumference differences and from the front or rear wheels being on a slippery surface while the opposite tires are not.

This code may also set on a hard acceleration on loose gravel or during other off road driving conditions. Check tire pressure of all the tires.
Check tire wear on all the tires.
Ask the customer what the road and driving conditions were like when the fault set.

Q: Were any problems found?

YES: Repair as necessary. If the code set during a front OR rear wheel spin condition, no repair is necessary. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test
NO: Go To 3

3. PCM

NOTE: Before continuing, check the PCM harness connector terminals for corrosion, damage, or terminal push out. Repair as necessary.

Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.

Q: Were there any problems found?

YES: Repair as necessary. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test
NO: Replace and program the Powertrain Control Module. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test