Installation

INSTALLATION
1. Position quarter trim panel on vehicle.

2. Pass second row seat belt, if equipped, through slot in quarter trim panel on long wheel base vehicle.

3. Pass first row seat belt through slot in quarter trim panel.

4. Connect wire connector into accessory power outlet, if equipped.

5. Align locating pins on backside of trim panel to mating holes in inner panels.

6. Position quarter trim panel on inner quarter panel.

7. Install screws attaching rear edge of quarter trim to attaching bracket or inner quarter panel.

8. Install screws attaching quarter trim to inner quarter panel in bolster area.

9. Install second row seat belts anchor on long wheel base vehicle. Tighten all seat belt bolts to 39 Nm (29 in. lbs.) torque.

10. Install first row seat belt anchor.

11. Install left D-pillar trim panel.

12. Install C-pillar trim panel.

13. Install upper left B-pillar trim on three door vehicle.

14. Install left quarter trim bolster.

15. Install front door sill plate on three door vehicle.

16. Install sliding door sill plate on four door vehicle.

17. Install second row seat, if equipped.

18. Install first row seat.

19. Connect the battery negative cable.