Installation

INSTALLATION

1. Apply Mopar(R) Engine RTV GEN II at the oil pump to engine block parting line (Figure 1).
2. Install the oil pan gasket to the block (Figure 2).
3. Install pan and tighten the screws to 12 Nm (105 in. lbs.).
4. Install structural collar and torque reaction bracket.
5. Lower vehicle and fill engine crankcase with proper oil to correct level.
6. Connect negative battery cable.




Figure 1 Oil Pan Sealing


1 - PLACE A 3 MM (1/8 INCH.) BEAD OF SEALANT AT THE PARTING LINE OF THE OIL PUMP BODY TO ENGINE BLOCK





Figure 2 Oil Pan Gasket Installation