Incomplete Power Close - Excessive Hall Effect Signal

Test 1:

Test 2-7:

Test 8-10:

SYMPTOM
INCOMPLETE POWER CLOSE - EXCESSIVE HALL EFFECT SIGNAL

WHEN MONITORED
Anytime the power sliding door is in the closing cycle.

SET CONDITION
If during a closing operation the PSD module detects an excessive hall effect signal time period, this code will set. Code will also set if obstacle detection becomes inoperative due to a hall effect sensor failure or high effort on door during power up.

POSSIBLE CAUSES
- DTC present
- Power sliding door module - hall effect open
- Lower drive unit
- Binding door
- Hall effect ground circuit open
- Door motor hall effect supply wire open
- Door motor hall effect supply wire short to ground
- Door motor hall effect signal wire open
- Door motor hall effect signal wire short to ground
- Door motor assembly