Electronic Vehicle Information Center - Installation

INSTALLATION

1. Position the Electronic Vehicle Information Center (EVIC) module in the overhead console.

2. Install the ten screws holding the EVIC module in the overhead console.

3. Install the overhead console.

4. Connect the battery negative cable.

NOTE: If the EVIC module is being replaced, the tire pressure monitoring system (if equipped) must be retrained. Drive vehicle for a minimum of five minutes while maintaining a continuous speed above 15 mph (24 km/h). During this time the system will learn the new sensor ID code and will clear any DTC's automatically.

NOTE: If a new EVIC module has been installed, the compass will have to be calibrated and the variance set.