Power Sliding Door System

PUSH-PIN GROMMET REPLACEMENT

Push-pin grommets are used to hold and isolate the power sliding door motor to and from the door inner panel. This secures the door motor assembly to the inner panel and keeps the audible motor vibrations to a minimum. If a push-pin grommet shows signs of wear, it must be replaced. Follow the procedure below if replacement is necessary.

1. Remove the door motor from the door inner panel.

2. Using a trim panel tool (special tool #C-4755) or equivalent, remove the push-pin grommets from the inner panel by pulling them straight out(Figure 1).






Figure 1 SIDE DOOR MOTOR PUSH-PIN GROMMETS





3. Install the replacement push-pin grommets in the inner panel and install the door motor.