Removal

REMOVAL

1. Remove power steering pump from engine.

CAUTION: Do not hammer on power steering pump pulley or shaft to remove power steering pump pulley. This will damage pulley and power steering pump.

2. Mount Puller, Special Tool C-4333, or equivalent on power steering pump pulley hub. Mount Puller (with power steering pump) in a vise as shown (Figure 1); Do not mount pump in vise. Placing Puller in vise will keep shaft of pump from turning while removing pulley and help keep tension on Puller and pulley hub.




Figure 1 Pulling Pulley Using C-4333






3. Tighten Puller and remove pulley from shaft of power steering pump.

NOTE: Inspect pulley. Replace if pulley is bent, cracked, or loose.