Installation

INSTALLATION




Figure 1 Solenoid/Pressure Switch Assembly and Gasket







NOTE: If solenoid/pressure switch assembly is being replaced, it is necessary to perform the "Quick-Learn" procedure.

1. Install solenoid/pressure switch assembly and new gasket to transaxle(Figure 1).




Figure 2 Solenoid/Pressure Switch Assembly-to-Case Bolts






2. Install and torque three bolts (1) (Figure 2) to 12 Nm (105 in. lbs.).




Figure 3 Input Speed Sensor


1 - INPUT SPEED SENSOR


3. Install input speed sensor (1) (Figure 3)and torque to 27 Nm (20 ft. lbs.).




Figure 4 Transmission Connectors






4. Connect input speed sensor connector (2) (Figure 4).
5. Install solenoid/pressure switch 8-way connector and torque to 4 Nm (35 in. lbs.).
6. Install air cleaner assembly.
7. Connect battery negative cable.
8. If solenoid/pressure switch assembly was replaced, perform the "Quick-Learn" procedure.