Disassembly - Rear Bushing - Hydro

DISASSEMBLY - REAR BUSHING - HYDRO

1. Remove the lower control arm from the front suspension cradle.
2. Mount the lower control arm in a vise without using excessive clamping force.
3. Install Remover, Special Tool 8460, on hydro-bushing as shown (Figure 1). Removal Pin, Special Tool 8460-3, must extend though hole in center of bushing rear.




Figure 1 HYDRO-BUSHING REMOVAL






4. Tighten forcing screw of Bridge (Special Tool 8460-1), removing bushing from lower control arm.