Installation

LAMP




1. Check to be certain that the two rubber grommets (2) are in good condition and properly installed in the outer box side panel.

2. Position the rear lamp unit (5) to the lamp opening of the outer box side panel.

3. Reconnect the two wire harness connectors to the two bulb sockets on the back of the lamp housing.

4. Align the two ball studs (1) on the outboard side of the lamp housing with the two rubber grommets in the outer box side panel.

5. Using hand pressure, push firmly and evenly on the outboard side of the lamp until both ball studs snap into the rubber grommets.

6. Install and tighten the two screws (4) that secure the rear lamp unit to the side jamb (3) of the tailgate opening. Tighten the screws to 2 Nm (19 in. lbs.).

7. Reconnect the battery negative cable.