Installation

INSTALLATION




1. Clean the oil pan gasket mating surface of the bedplate and oil pan.
2. Inspect integrated oil pan gasket, and replace as necessary.
3. Position the integrated oil pan gasket/windage tray assembly.
4. Install the oil pickup tube
5. If removed, install stud at position No. 9.
6. Install the mounting bolt and nuts. Tighten nuts to 28 Nm (20 ft. lbs.).
7. Position the oil pan and install the mounting bolts. Tighten the mounting bolts to 15 Nm (11 ft. lbs.) in the sequence shown.
8. Install structural dust cover, if equipped.
9. Lower the engine into mounts using Special Tool 8534.
10. Install both the left and right side engine mount through bolts. Tighten the nuts to 68 Nm (50 ft. lbs.).
11. Remove Special Tool 8534.
12. Install the intake manifold.
13. Fill engine oil.
14. Reconnect the negative battery cable.
15. Start engine and check for leaks.