Installation

LAMP

NOTE: The appearance of the Dodge and Chrysler rear lamp units is unique, but the service procedures for removing and installing either lamp are the same.





1. Check to be certain that the two rubber grommets (4) are in good condition and properly installed in the quarter panel (3).

2. Position the rear lamp unit to the lamp opening of the quarter panel.

3. Reconnect the wire harness connector (2) to the lamp socket plate connector (1) (Dodge), or the lamp pigtail wire connector (Chrysler) and engage the connector lock feature.

4. Align the two ball studs on the outboard side of the rear lamp housing with the two rubber grommets in the quarter panel.

5. Using hand pressure, push firmly and evenly on the outboard side of the lamp until both ball studs snap into the rubber grommets.





6. Install the two plastic push-pin fasteners (3) that secure the rear lamp unit (2) to the side jamb of the liftgate opening pillar (1).

7. Reconnect the battery negative cable.