Removal

BULB

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the battery negative cable.

2. Remove the center bezel lamp unit (4) from the instrument panel.

3. Depress the latch tab (2) and slide the hood (1) off of the end of the lamp housing.

4. Pull the base of the bulb (3) straight out of the bulb holder within the lamp housing.