Third Row Center

THIRD ROW CENTER

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler Mopar(R) Parts Catalog.





1. Remove the upper liftgate opening trim from the inside of the rear header (1) in the upper liftgate opening.

2. Route the seat belt (2) and lower anchor latch plates through the clearance hole in the upper liftgate opening trim panel.

3. Pull the top of the left upper D-pillar trim away from the D-pillar far enough to access the retractor mounting provisions.

4. Remove the screw (4) that secures the retractor bracket to the inside of the rear header near the left D-pillar (3).

5. Remove the third row center seat belt and retractor from the rear header as a unit.