Right Doors Unlock Only

*RIGHT DOORS UNLOCK ONLY





For a complete wiring diagram refer to Diagrams/Electrical.





NOTE: If the P392 circuit is shorted, the fuse may blow after one attempt to operate the locks.

Diagnostic Test

1.CHECK FOR ACTIVE DTC B182D-ALL DOOR LOCK OUTPUT CIRCUIT SHORTED TO GROUND

Turn the ignition on.

With the scan tool, read active DTC's.

Does the scan tool display any Door Lock related DTC's?

No

- Go To 2

Yes

- Refer to the symptom list for problems related to Power Door Locks. Diagnose and repair the DTC's

2.CHECK (P392) DOOR LOCK DRIVER RIGHT DOORS FOR SHORT TO GROUND





Turn the ignition off.

Disconnect the Cluster C1 connector.

Measure the resistance between ground and the (P392) Door Lock Driver Right Doors circuit.

Is the resistance below 1000.0 ohms?

No

- Replace the Cluster.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

Yes

- Repair the (P392) Door Lock Driver Right Doors circuit for a short to ground.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test