Installation

INSTALLATION
1. Install park assist sensor(s) (Figure 1), if necessary.





Figure 1 PARK ASSIST SENSOR





2. Hoist and support vehicle with safety stands.

3. Position rear fascia on vehicle (Figure 2) and (Figure 3).

4. Connect the rear park assist wire connector (Figure 4), if equipped.

5. Engage front edge of fascia under the liftgate tower. Install screw in liftgate tower right side and left side.

6. Engage sides of fascia to top and front edge of the rear fascia brackets.


NOTE: Verify fascia is still engaged under the liftgate. Ensure acceptable and consistent gap between liftgate and fascia.

7. Install three screws attaching rear fascia to rear fascia brackets, right side and left side.

8. Install the four plastic push pins attaching bottom of rear fascia to fascia support.

9. Lower vehicle.

10. Install the two screws attaching the upper fascia to the fascia support.






Figure 2 REAR BUMPER FASCIA










Figure 3 REAR FASCIA WITH PARK ASSIST SENSOR










Figure 4 PARK ASSIST WIRE CONNECTOR