Installation

INSTALLATION

1. Install front wiper motor assembly onto wiper tub.

2. Connect the electrical connector to the front wiper motor assembly.

3. Install the four mounting nuts. Tighten nuts to 9 Nm (80 in.lbs.).

4. Push the four inner support braces onto the studs and install the four nuts. Tighten the nuts to 9 Nm (80 in.lbs.).

5. Install the four bolts underneath the wiper tub inner braces that hold the wiper tub to the bulkhead. Tighten the bolts to 17 Nm (150 in.lbs.).

6. Install the four nuts holding the wiper tub to the lower windshield fence line. Tighten nuts to 7 Nm (65 in.lbs.).

7. Apply grease to drive link bushings.

NOTE: Make sure to use Mopar(R) approved grease.

8. Attach the driver and passenger side outer wiper linkage to the inner pivots on the front motor assembly and firmly snap into place.

CAUTION: Do not apply too much force to engage link bushing or damage can occur to the drive link bushing.

9. Position the cowl grille in place.

10. Install the washer hose and grommet into the wiper tub.

NOTE: Be sure to properly seat the washer hose grommet into the bottom of the wiper tub.

11. Connect the washer hose at the in-line connector located by the air cleaner housing.

12. Install the cowl grille.

CAUTION: Be careful not to scratch the cowl grille on the corner of the hood.

13. Connect the battery negative cable.

14. Verify that the wiper motor is in the Park position by cycling the wipers system. When done, remove keys from ignition.

15. Install the wiper arms.

16. Align the wiper arms and tighten nuts to 35 Nm (25 ft.lbs.).

17. Install the wiper arm nut caps.