Installation

INSTALLATION




1. Before proceeding with the following repair procedure, review all warnings and cautions.


NOTE: Do not reuse the seat fasteners, always replace with new ones.

2. Position each seat section into the vehicle and tip back.

3. Install the nuts (4) attaching the center seat section (2) to the other seat, and tighten to 25 Nm (18 ft. lbs.).





4. Install the nuts (2 and 4) attaching the center seat section to the other seat, and tighten to 25 Nm (18 ft. lbs.).





5. Connect the electrical connectors (1).





6. Roll the seat assembly forward and install new rear bolts (2). Tighten the bolts (2) to 40 Nm (30 ft. lbs.).

7. Fold the seat backs up and slide the seats (1) to the rear.

8. Install new front bolts (4) and tighten to 28 Nm (21 ft. lbs.).

9. If equipped, install the floor console as necessary.