Instrument Cluster - Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.







1. Disconnect and isolate the battery negative cable.

2. Remove the cluster bezel from the instrument panel.

3. Remove the four screws (2) that secure the instrument cluster (1) to the instrument panel structural support (3).







4. Pull the instrument cluster rearward far enough to access and disconnect the three instrument panel wire harness connectors (2) from the connector receptacles (1), C1, C3 and C4 from right to left on the back of the cluster housing.

5. Remove the instrument cluster from the instrument panel.