Lamp - Pick-Up

LAMP - PICK-UP




1. Check to be certain that the two plastic grommet clips (2) are in good condition and properly installed in the outer box side panel (3).

2. Position the rear lamp unit (5) to the lamp opening of the outer box side panel.

3. Reconnect the two wire harness connectors (4) to the two bulb sockets on the back of the lamp housing.

4. Align the two ball studs on the outboard side of the rear lamp housing with the two plastic grommets in the outer box side panel.

5. Using hand pressure, push firmly and evenly on the outboard side of the lamp until both ball studs snap into the plastic grommet clips.

6. Install and tighten the two screws (1) that secure the rear lamp unit to the side jamb of the tailgate opening. Tighten the screws to 2 Nm (19 in. lbs.).

7. Reconnect the battery negative cable.