Lamp/Switch

LAMP/SWITCH

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.







1. Disconnect and isolate the battery negative cable.

2. Open the glove box door.

3. Reach through the window in the instrument panel (2) glove box opening behind the switch to access and depress the retaining latch on either side of the glove box lamp and switch unit (3).

4. While holding the retaining latch depressed, push the glove box lamp and switch unit out through the mounting hole in the face of the instrument panel.

5. Disconnect the wire harness connector (1) from the glove box lamp and switch.

6. Remove the lamp and switch unit from the instrument panel.