Installation

INSTALLATION





NOTE: If the ABM (2) is being replaced with a new ABM is must be reprogrammed with the use of a scan tool.

1. Install HCU/ABM (3) on the mounts to the battery tray (4) and Tighten the bolts to 15 Nm (11 ft. lbs.).
2. Install the brake lines to the HCU (3) and tighten to 19 Nm (170 in. lbs.).
3. Install the electrical harness connectors to the HCU/ABM (3) and push down on the release to secure the connectors.
4. Install the battery.
5. Install the battery cables to the battery.
6. Bleed ABS brake system.