B1644

B1644-REAR LEFT TURN CONTROL CIRCUIT HIGH






For a complete wiring diagram refer to Diagrams/Electrical.

- When Monitored:

Continuously

- Set Condition:

When the Totally Integrated Power Module detects a short to battery on the Control circuit.






Diagnostic Test

1. TEST FOR INTERMITTENT CONDITION

Turn the ignition on.

Clear all TIPM DTC's

Turn the Left Turn Signal on.

With the scan tool, read DTC's.

Does the scan tool read: B1644-REAR LEFT TURN CONTROL CIRCUIT HIGH?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

2. LEFT REAR TURN SIGNAL BULB

Turn the ignition off.

Inspect the Left Rear Turn Signal Bulb Assembly.

Is the inoperative bulb OK?

Yes

- Go To 3

No

- Replace the Inoperative bulb.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

3. (L63) LEFT TURN SIGNAL DRIVER CIRCUIT





Turn the ignition off.

Disconnect the TIPM C6 harness connector.

Disconnect the Left Rear Tail Lamp assembly.

Measure the resistance of the (L63) Left Rear Turn Signal Driver circuit.

Is the resistance above 5.0 ohms?

Yes

- Repair the (L63) Turn Signal Driver circuit for an open.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Go To 4

4. TOTALLY INTEGRATED POWER MODULE





Turn the ignition on.

Measure for voltage on the (L63) Left Rear Turn Signal Driver circuit.

Is there any voltage present?

Yes

- Repair short to voltage on the (L63) Left Rear Turn Signal Driver circuit.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test