B2347

B2347-WIPER MOTOR LOW SPEED CONTROL CIRCUIT HIGH






For a complete wiring diagram refer to Diagrams/Electrical.

- When Monitored:
- With the Windshield Wipers are turned on.
- Set Condition:
- When the TIPM detects a HIGH condition.






Diagnostic Test

1. INTERMITTENT CONDITION

Turn the ignition on.

With the Scan Tool, clear all TIPM DTC's.

Turn the Windshield Wipers on.

With the Scan Tool read the DTC information.

Does the Scan Tool read: B2347-WIPER MOTOR LOW SPEED CONTROL CIRCUIT HIGH?

Yes

- Go To 2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

2. (W3) WIPER LOW SPEED CONTROL OUTPUT CIRCUIT OPEN





Turn the ignition off.

Disconnect the TIPM C10 harness connector.

Disconnect the Windshield Wiper harness connector.

Measure the resistance of the (W3) Wiper Low Speed Control Output circuit.

Is the resistance above 5.0 ohms?

Yes

- Repair the (W3) Wiper Low Speed Control Output circuit for an open condition.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the Totally Integrated Power Module (TIPM).
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test