C120D

C120D-REAR TRACTION CONTROL PRIME VALVE CONTROL CIRCUIT LOW





For a complete wiring diagram Refer to Diagram/Electrical. Electrical Diagrams

- When Monitored:

Continuous

- Set Condition:

The electrical feedback of the power stage does not correspond with the activation of the respective valve.





Diagnostic Test

1. HIGH RESISTANCE IN B+ CIRCUITS





Turn key off.

Disconnect the ABS Module harness connector.

NOTE: Check connector - Clean/repair as necessary.

Turn key on, engine off.

With a test light connected to ground check (A107) Fused B+, (A111) Fused B+ and (F960) Fused ignition switch output.

Is the test light bright like when connected to the battery?

Yes

- Go to 2

No

- Repair the high resistance in the circuits.
- Perform ABS VERIFICATION TEST - VER 1. Verification Tests

2. HIGH RESISTANCE IN GROUND CIRCUITS





With a test light Connected to B+ check (Z107) Ground and (Z127) Ground.

Is the test light bright like when connected to the battery?

Yes

- Replace the ABS.
- Perform ABS VERIFICATION TEST - VER 1. Verification Tests

No

- Repair the high resistance in the circuits.
- Perform ABS VERIFICATION TEST - VER 1. Verification Tests