Installation

INSTALLATION





NOTE: Discard the nuts and bolts and do not reuse. New nuts and bolts should be used when replacing or servicing the control arms.

1. Position the lower control arm (2) at the axle bracket (3) and frame rail bracket (1).
2. Install the rear bolt and finger tighten the nut.




3. Install the cam bolt (1), cam and nut in the axle and align the reference marks.
4. Remove support and lower the vehicle.
5. Tighten cam nut at the axle bracket to 190 Nm (140 ft. lbs.). Tighten rear nut at the frame bracket to 230 Nm (170 ft. lbs.).