Right

RIGHT





NOTE: Discard the nuts and bolts and do not reuse. New nuts and bolts should be used when replacing or servicing the control arms.

1. Position the upper control arm (4) at the axle and frame rail.
2. Install the bolts, then finger tighten the nuts.
3. Reconnect the rubber exhaust mounts at the muffler.
4. Reconnect the exhaust at the manifolds.
5. Install the transmission crossmember.
6. Remove the supports and lower the vehicle.
7. Tighten nut at the axle bracket to 163 Nm (120 ft. lbs.). Tighten nut at frame bracket to 163 Nm (120 ft. lbs.).