B2113

B2113-5 VOLT SUPPLY CIRCUIT HIGH






For a complete wiring diagram refer to Diagrams/Electrical.

- When Monitored:

With the ignition on.

- Set Condition:






Diagnostic Test

1. CHECK FOR ACTIVE DTC

With the scan tool, read the DTCs.

Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.

With the scan tool, read the DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

2. A/C PRESSURE TRANSDUCER





Disconnect the A/C Pressure Transducer harness connector.

Wait 30 seconds

With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 3

No

- Replace the A/C Pressure Transducer.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

3. SHIFT MOTOR/MODE SELECTOR ASSEMBLY





Disconnect the Shift Motor/Mode Selector Assembly harness connector.

With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 4

No

- Replace the Shift Motor/Mode Selector Assembly.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

4. (T103) 5-VOLT SUPPLY SHORTED TO VOLTAGE





Turn the ignition off.

Disconnect the TIPM C4 harness connector.

Turn the ignition on.

Measure the voltage of the (T103) 5-Volt Supply circuit.

Is the voltage above 10 volts?

Yes

- Repair the (T103) 5-Volt Supply circuit for a short to voltage.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Go To5

5. (C818) A/C PRESSURE 5-VOLT SUPPLY SHORTED TO VOLTAGE





Turn the ignition off.

Disconnect the TIPM C7 harness connector.

Turn the ignition on.

Measure the voltage of the (C818) A/C Pressure 5-Volt Supply circuit.

Is the voltage above 10 volts?

Yes

- Repair the (C818) A/C Pressure 5-Volt Supply circuit for a short to voltage.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test

No

- Replace the TIPM.
- Perform BODY VERIFICATION TEST - VER 1. Body Verification Test