Lamp - Pick-Up

LAMP - PICK-UP




1. Disconnect and isolate the negative battery cable.

2. Lower the tailgate to access and remove the two screws (1) that secure the rear lamp unit (5) to the side jamb of the tailgate opening.

3. Pull the outboard side of the rear lamp unit rearward far enough to unsnap the two ball studs on the outboard side of the lamp housing from the two plastic grommet clips (2) in the outer box side panel (3).




4. Pull the lamp away from the vehicle far enough to access and disconnect the two wire harness connectors (3) from the two bulb sockets (2 and 4) on the back of the lamp housing.

5. Remove the lamp from the lamp opening of the outer box side panel.