EBC 340/445ESP AWAL

U0126-LOST COMMUNICATION WITH STEERING ANGLE SENSOR

For a complete wiring diagram Refer to Diagram/Electrical. Electrical Diagrams

- When Monitored:
- With the ignition on
- Battery voltage between 10 and 16 volts
- IOD fuse installed
- Set Condition:

If the Anti-Lock Brakes Module fails to receive bus messages from the Steering Angle Sensor for approximately 500 ms.





Diagnostic Test

1. VERIFY DTC IS ACTIVE

NOTE: Ensure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

With the scan tool, read active DTCs.

Is this DTC active?

Yes

- Go To 2

No

- Perform the ABS Intermittent Condition diagnostic procedure.
- Perform ABS Intermittent Condition Test

2. VERIFY THAT THE STEERING ANGLE SENSOR IS ACTIVE ON THE BUS

Turn the ignition on.

With the scan tool, select Network Diagnostics.

Verify that the Steering Angle Sensor is active on the bus.

Is the Steering Angle Sensor active on the bus?

Yes

- Go To 3

No

- Refer to Communications for a no response test procedure.
- Perform BODY VERIFICATION TEST - VER 1. Verification Tests

3. STEERING ANGLE SENSOR

Replace the Steering Angle Sensor.

Perform ABS Verification ABS Verification Test.

With the scan tool, read ABS DTCs.

Did DTC U0126-LOST COMMUNICATION WITH STEERING ANGLE SENSOR reset?

Yes

- Replace the Anti-Lock Brakes Module.
- Perform ABS Verification ABS Verification Test

No

- Test Complete.