Installation

INSTALLATION

Mini Floor Console





1. Position the console and seat the front clips (1) fully.

2. Install the bolts (2).





3. Install the bolts (2) that secure the rear console (1) to the floor panel.





4. Install the inserts.

5. Install the gear shift lever extension.

6. Install the 4WD gear shift boot.


Full Floor Console





1. Before proceeding with the following repair procedure, review all warnings and cautions.


NOTE: Do not reuse the seat fasteners, always replace with new ones.

2. Position the center seat console onto the front seat assembly and roll the seat assembly back in the vehicle.

3. Install new nuts (4) attaching the center console to the drivers (3) and passenger seat.

4. Connect the electrical connector (1) - if equipped.

5. Tighten the nuts (4) to 25 Nm (18 ft. lbs.).





6. Install new nuts (2) attaching the center console (1) to the drivers and passenger seat.

7. Tighten the nuts to 25 Nm (18 ft. lbs.).

8. Connect the electrical connector (3 and 5 - if equipped).





9. Roll the seat assembly forward and install new rear bolts (2).

10. Connect the 12v power supply electrical connector (3) - if equipped.

11. Tighten the rear bolts to 40 Nm (30 ft. lbs.).

12. Fold the seat backs up and slide the seats to the rear.

13. Install new front bolts (4) and tighten to 28 Nm (21 ft. lbs.).