Installation

INSTALLATION





WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.

1. Install remote radio switch (1) to the steering wheel.

2. Connect the wire harness to the remote radio switch.

3. Install the speed control switches (2).

4. Install the driver airbag.

5. Connect the battery negative cable.