Removal

REMOVAL





CAUTION: Make sure that the key is in the off position in the ignition lock and wait at least 20 seconds before disconnecting or connecting the battery isolating connector. You could otherwise damage electrical system components.

1. Isolate the starter battery from the vehicle electrical system by disconnecting the battery isolating connector.
a. Take the key out of the ignition lock and wait for approx. 20 seconds.
b. Pull down on the isolating connector locking tab (2).
c. Pull the connector (1) away from the grounding stud
d. Clamp connector under the accelerator pedal so that it cannot make contact with the ground pin.




2. Remove the front door upper sill trim screws (3).
3. Remove the front door upper sill trim (2).
4. Remove the front driver floor covering (1).




5. Remove the 4 battery access cover screws (1).
6. Remove the battery access cover (2) by sliding it rearward and up.




7. Disconnect the battery negative cable (5).
8. Remove the battery positive cable cover (4).
9. Disconnect the battery positive cable (3).
10. Disconnect the battery vent tube and elbow from the battery vent cover (1).
11. Remove the battery holdown bolt (6) and remove the holdown.
12. Slide the battery forward and lift the battery out of the battery well using the built in handles (2).